Materials Transactions Online

Materials Transactions, Vol.59 No.2 (2018)

151-164 :
Formation Mechanism of Lath Martensite in Steels
Yoshinori Murata
165-165 :
PREFACE
Masanori Kajihara
166-171 :
Very Fine Structured DP Steel with Tempered-Martensite Matrix Fabricated by Fast Heating
Nobuo Nakada, Masahiro Tsukahara, Kengo Fukazawa and Yoshitaka Misaka
172-175 :
Molecular Dynamics Simulation of Local Structure Evolution in Cu Amorphous during Uniaxial Tension and Compression
Ye Li, Hongye Liang and Xing Zhang
176-181 :
Effect of Thermal Cycles on Microstructure of Er2O3 Thin Film on SUS316 Substrate with Y2O3 Buffer Layer Fabricated by MOCVD Method
Masaki Tanaka, Seungwon Lee, Kenji Matsuda, Yoshimitsu Hishinuma, Katsuhiko Nishimura, Teruya Tanaka and Takeo Muroga
182-187 :
Microstructural Subsequence and Phase Equilibria in an Age-Hardenable Cu-Ni-Si Alloy
Satoshi Semboshi, Mikio Ishikuro, Akihiro Iwase and Takayuki Takasugi
188-197 :
Effects of Liquid Indium Particles on Recrystallization and Grain Growth of ╬▒Fe in Fe-In Alloys
Takehito Hagisawa, Toshihiro Omori, Ikuo Ohnuma, Ryosuke Kainuma and Kiyohito Ishida
198-203 :
Growth Behavior of Compounds during Reactive Diffusion in the Solid-Cu/Liquid-Sn System
S. Murakami, M. O and M. Kajihara
204-213 :
Effects of Tungsten Addition and Isothermal Annealing on Microstructural Evolution and Hardening Behavior of Two-Phase Ni3Al-Ni3V Intermetallic Alloys
Akinori Uekami, Satoshi Semboshi, Yasuyuki Kaneno and Takayuki Takasugi
214-223 :
Anisotropic Ferrite Growth and Substructure Formation during Bainite Transformation in Fe-9Ni-C Alloys: In-Situ Measurement
Tadashi Furuhara, Shin-ya Abe and Goro Miyamoto
224-229 :
Martensitic Transformation and Magnetic Properties of Ni-Co-Mn-In-Gd Ferromagnetic Shape Memory Alloys
Kaifeng Li, Li Gao and Yongcheng Liang
230-236 :
Interface-Related Shear Banding Deformation of Amorphous/Crystalline CuZr/Cu Nanolaminates by Molecular Dynamics Simulations
Yan Cui, Yoji Shibutani, Ping Huang, Fei Wang, Kewei Xu and Tianjian Lu
237-243 :
Water Droplet Erosion Resistance of Aluminizing Diffusion Coatings on Steel Tubes
Yoshinori I. Oka, Keiji Ishikawa and Hideshi Tezuka
244-250 :
Observation of Cation Diffusion and Phase Formation between Solid Oxide Layers of Lanthanum Gallate-Based Fuel Cells
Hiromi Eba, Chikako Anzai and Satoshi Ootsuka
251-254 :
Formation of Antireflection Thin-Film Glasses Using Organopolysiloxane by Low-Temperature Process and Surface Modification
Hiroyuki Miwa, Atsuki Kodama, Htay Win, Koichi Murakami, Taku Takahashi, Fumitaka Ohashi and Shuichi Nonomura
255-264 :
Solidification Microstructure of AlCoCrFeNi2.1 Eutectic High Entropy Alloy Ingots
Takeshi Nagase, Mamoru Takemura, Mitsuaki Matsumuro and Toru Maruyama
265-271 :
Viscous Sintering and Structural Stabilization of Amorphous B4C Powder
Hiroshi Kimura
272-279 :
Effect of Calcium on the Combustion Behavior of Molten AZ91 Magnesium Alloy
Hiroyuki Kawabata, Yusuke Yagi, Yuko Aoki, Hajime Kato, Koshiro Kitayama and Kazuma Hibi
280-289 :
Friction and Wear Behaviors of Carbon Nanotube Reinforced Silica and Alumina Matrix Composites Fabricated by Catalyst Sol-Gel and CVD Process
Kuo-Jung Lee, Yu-Ting Yeh, Huy-Zu Cheng and Hsun-Yu Lin
290-296 :
Recovery of Calcium Fluoride from Highly Contaminated Fluoric/Hexafluorosilicic Acid Wastewater
Masao Morita, Giuseppe Granata and Chiharu Tokoro
297-302 :
Removal of Chloride Ions from an Aqueous Solution Containing a High Chloride Concentration through the Chemical Precipitation of Friedel's Salt
Li Pang Wang, Wei Hao Lee, Shu Man Tseng and Ta Wui Cheng
303-310 :
High Temperature Characterization of Binary and Ternary Bi Alloys Microalloyed with Cu and Ag
Meiqi Yu, Kazuhiro Matsugi, Zhefeng Xu, Yongbum Choi, Jinku Yu, Satoshi Motozuka, Yoshiyuki Nishimura and Ken-ichiro Suetsugu
311-315 :
Removal of Arsenic from Crude Tin by Vacuum Distillation
Zhenghao Pu, Jibiao Han, Yifu Li, Yongnian Dai, Bin Yang and Anxiang Wang
316-319 :
Nondestructive Evaluation by Reversible Magnetic Permeability of the Residual Life of Ferritic 9Cr Steel Subjected to Creep-Fatigue Damage
Chungseok Kim
320-323 :
Defect Imaging from a Remote Distance by Using Scanning Laser Source Technique with Acoustic Microphones
Atsuya Maeda and Takahiro Hayashi
324-326 :
Joining of Anodized and Stacked Aluminum Sheets by Copper Electrodeposition: Nano-Anchor Effect
Masataka Hakamada, Yohei Kohashi, Yuriko Yamano and Mamoru Mabuchi

[JIM HOME] [JOURNAL ARCHIVES]

© 2018 The Japan Institute of Metals and Materials
Comments to us : editjt@jim.or.jp