日本金属学会誌

J. Japan Inst. Met. Mater, Vol. 82, No. 08 (2018),
pp. 289-296

Surface Reforming of Ti Wire by Dipping Heating of Ti Wire into Pure Ni, Ni/Ti, Ni/Al Mixed Powders

Kaichi Hashi 1, Atsushi Hibino 2 and Yuta Tamura 2

1 Department of Mechanical System Engineering, Graduate School of Engineering, Toyama Prefectural University
2 Department of Mechanical System Engineering, Inst. of Technology, Toyama Prefectural University

Abstract:

The surface reforming of Ti wire by powder metallurgy was investigated in this study. Pure Ni powder, Ni/Ti powder and Ni/Al powder were used as coating materials. A piece of Ti wire (φ=1.0 mm) was placed in an alumina crucible, and coating materials (Ni powder, Ni/Ti premixed powder, Ni/Al premixed powder) were filled around the Ti wire. The alumina crucible was vacuum sealed in a quartz tube with 2 ×10-3 Pa. The quartz tube was heated in an electric furnace for 60 min. For the test piece obtained, microstructure, phase and Vickers hardness were measured. A uniform compound layer was formed when the Ni / Al premixed powder was used as the coating material. The intermetallic compound layer was consisted of (Ti3Al+NiTi), (Ti3Al+Ti2Ni+τ4) phases. The surface reforming of Ti wire was able to be performed by dipping heat of Ti wire into Ni/Al premixed powder.

[doi:10.2320/jinstmet.J2018005]


(Received 2018/01/22)

Keywords:

surface reforming, pure nickel powder, nickel/titanium mixed powder, nickel/aluminum mixed powder, formation of intermetallic compound layer


PDF(Free)PDF (Free)     Table of ContentsTable of Contents

Please do not copy without permission.