日本金属学会誌

J. Japan Inst. Metals, Vol. 69, No. 8 (2005),
pp. 587-595

Effects of Applied Strain and Subsequent Heat Treatment at Intermediate Temperature on Mechanical Properties of a Thin Plate of Ti-51 at%Ni of Shape Memory Alloy

Nagatoshi Okabe1, Hiromasa Senba1,, Toru Yamaji1,, Keisuke Okita1,\footnotemark[1] and Kiyoshi Yamauchi2

1Department of Mechanical Engineering, Ehime University, Matsuyama 790-8577
2Biomedical Engineering Research Organization, Tohoku University, Sendai 980-8575

Abstract:

Attempts have been made to develop new types of seismic devices using shape memory alloys. They are a single-stage bellows which are processed from thin-walled tubes by employing the rubber bulge method and then are annealed at 400°C for the shape-memory treatment. As strain distribution is induced on the bulged part due to the process, it is significant to know the effects of pre-strain and the subsequent heat-treatment on the mechanical properties of the material for tube when designing the bellows shapes for the seismic structures. Thus, tensile tests and thermal analysis were conducted before and after the heat treatment on rectangular specimens cut from the tubes.
In this paper, the oxidization method was first attempted to observe distinctively both regions of the stress induced martensite (SIM) transformation and twin deformation generated while applying strain to the specimens. It became clear that the micro-structure in the SIM area had a changed R phase from the austenite phase at room temperature after being annealed at 400°C. From the experimental and analytical results for the specimens, the mechanical behavior was classified broadly into two conditions as follows: (1) the mechanical behavior can be formulated on the basis of a series-model consisting of areas of both R phase and austenite considering the area-ratio of these phases until the SIM transformation has expanded over the whole specimen, and (2) after that, the mechanical behavior can be formulated using the exponential function for the applied strain as a parameter.


(Received 2005/2/22)

Keywords:

shape memory alloy, applied strain, heat treatment, titanium-nickel alloy, stress-induced martensite transformation, differential scanning calorimeter, rhombohedral phase, austenite phase


PDF(Free)PDF (Free)     Table of ContentsTable of Contents

Please do not copy without permission.