Materials Transactions Online

Materials Transactions, Vol.59 No.4 (2018)

509-517 :
Crystallography and Energetics of Second Phases and Interfaces
Masaharu Kato
518-527 :
Effect of Microstructural Continuity on Room-Temperature Fracture Toughness of ZrC-Added Mo-Si-B Alloys
Shunichi Nakayama, Nobuaki Sekido, Sojiro Uemura, Sadahiro Tsurekawa and Kyosuke Yoshimi
528-537 :
Effects of Process Control Agents on the Mechanical Alloying Behavior of Nb-Ti-Si Based Alloy
Lijing Zhang and Xiping Guo
538-545 :
Grain Boundary Sliding-Induced Creep of Powder Metallurgically Produced Nb-20Si-23Ti-6Al-3Cr-4Hf
C. Seem├╝ller and M. Heilmaier
546-555 :
Influence of Atomic Size Factors on the Phase Stability of Laves Phase in Nb-Cr-Ni-Al and Nb-V-Ni-Al Phase Diagrams
Takuya Yamanouchi and Seiji Miura
556-562 :
Microstructural Investigation of Oxidized Complex Refractory High Entropy Alloys
Kai-Chi Lo, An-Chou Yeh and Hideyuki Murakami
563-567 :
Effect of Cr on the Oxidation Resistance of Co-Based Oxide Dispersion Strengthened Superalloys
Hao Yu, Shigeharu Ukai, Shigenari Hayashi and Naoko Oono
568-574 :
Numerical Analysis of Effects of Compressive Strain on the Evolution of Interfacial Strength of Steel/Nickel Solid-State Bonding
Kittipan Pongmorakot, Shoichi Nambu and Toshihiko Koseki
575-579 :
Isothermal Section of Ga-Ru-Cu Ternary Phase Diagram at 1073 K: Formation of New Ternary Phase, Ga4Ru3Cu, and Its Structural Relation with the GaRu ╬▓-Phase
Takanobu Hiroto, Kazuya Honda, Kazue Nishimoto, Koichi Kitahara and Kaoru Kimura
580-584 :
Description of Thermal Vacancies in the CALPHAD Method
Taichi Abe, Kiyoshi Hashimoto and Masato Shimono
585-589 :
Tunnel-Type Magneto-Dielectric Effect and Its Annealing Study in Co-SiO2 Granular Films
Yang Cao, Nobukiyo Kobayashi, Shigehiro Ohnuma and Hiroshi Masumoto
590-597 :
Effects of Scandium and Zirconium Addition on Recrystallization Behavior of Al-Mg-Si Alloy
Ken-ichi Ikeda, Takuya Takashita, Ryutaro Akiyoshi, Satoshi Hata, Hideharu Nakashima, Kazuhiro Yamada and Kenji Kaneko
598-601 :
Fabrication of Electrodeposited Permalloys with High Strength and High Ductility
Mizuki Kanetake, Yorinobu Takigawa, Tokuteru Uesugi and Kenji Higashi
602-611 :
Plastic Deformation Behavior of Mg-Y Alloy Single Crystals Observed Using In Situ Brinell Indentation
Takahiro Mineta, Seiji Miura, Kazuhiko Oka and Tatsuya Miyajima
612-619 :
Effect of Sintering Temperature on Fatigue Crack Propagation Rate of Sintered Ag Nanoparticles
Ryo Kimura, Yoshiharu Kariya, Noritsuka Mizumura and Koji Sasaki
620-624 :
Lead-Based Anodes for Copper Electrowinning: Effect of Grain Size on Mechanical and Anticorrosion Properties
Carlos Camurri, Claudia Carrasco, Yasmin Maril and Jonathan Peralta
625-633 :
Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum
Tong Shi, Xiang Chen, Ying Cheng, Yuan Liu, Huawei Zhang and Yanxiang Li
634-641 :
Equilibrium Modeling for Solvent Extraction of Nickel and Ammonia from Alkaline Media with the Extractant LIX84-I
Shubin Wang, Jie Li, Hirokazu Narita and Mikiya Tanaka
642-647 :
Effect of Cr Diffused Layer Formed by AIH-FPP Treatment on Adhesion of DLC Films to a Carbon Steel Substrate
Shogo Takesue, Hiroyuki Akebono, Mizuki Furukawa, Shoichi Kikuchi, Jun Komotori and Hirorou Nomura
648-655 :
Visible-Light-Assisted Silver Ion Reduction through Silver Diammine and Citrate Aggregation, and Silver Nanoparticle Formation
Kazuhiro Hashiguchi, Masashi Kamiya and Hisanori Tanimoto
656-662 :
Numerical Analysis of Effect of Pin Tip Radius on Residual Stress Distribution in Ultrasonic Impact Treatment
Takahiro Ohta
663-668 :
Influence of Additives on Surface Roughness at Turned End Face of Fe-Cu-C Sintered Steel
Kouichi Nushiro
669-673 :
Microstructure and Mechanical Properties of Mg-Gd-Y-Zn-Zr Alloy Prepared by Repetitive Upsetting and Extrusion
Zhimin Zhang, Yue Du, Guanshi Zhang, Zhaoming Yan, Jianmin Yu and Mu Meng
674-678 :
Pseudo-Superplastic Characteristics of ZK60 Alloy with Fibrous Microstructure
Cheng-Yu Wang, Jian-Yih Wang, Akhmd Saufan and Yen-Pei Fu
679-684 :
Magnetostrictive Fe-Ga Wires for Application in the High-Temperature Waveguide Device
Jiheng Li, Mingming Li, Xing Mu, Xiaoqian Bao and Xuexu Gao
685-689 :
Microstructure and High Temperature Charge-Discharge Characteristics of 3D Additive Manufacturing Produced Mg-Ni Anode
Yen-Ting Chen, Fei-Yi Hung, Truan-Sheng Lui and Huey-Pyng Tan
690-693 :
Dependence of Reduction Behavior of Ti in Molten CaCl2 on Various Calcium Titanate
Haruka Okada, Kakeru Shimokawa, Taiki Morishige and Toshihide Takenaka
694-697 :
Clinching of Similar and Dissimilar Sheet Materials of Galvanized Steel, Aluminium Alloy and Titanium Alloy
Mingming Chu, Xiaocong He, Jie Zhang and Lei Lei

[JIM HOME] [JOURNAL ARCHIVES]

© 2018 The Japan Institute of Metals and Materials
Comments to us : editjt@jim.or.jp