Materials Transactions Online

Materials Transactions, Vol.53 No.4 (2012)

583-583 :
PREFACE
Yoshikazu Shinohara, Osamu Umezawa, Hideki Abe, Ichiro Daigo and Eiji Yamasue
584-587 :
Fabrication and Tensile Tests of Aluminum Foam Sandwich with Dense Steel Face Sheets by Friction Stir Processing Route
Yoshihiko Hangai, Nobuyuki Ishii, Shinji Koyama, Takao Utsunomiya, Osamu Kuwazuru and Nobuhiro Yoshikawa
588-591 :
Effects of Low Rotational Speed on Crystal Orientation of Bi2Te3-Based Thermoelectric Semiconductors Deformed by High-Pressure Torsion
Maki Ashida, Natsuki Sumida, Kazuhiro Hasezaki, Hirotaka Matsunoshita and Zenji Horita
592-596 :
Synthesis of Zeolitic Material from Paper Sludge Ash Using Diatomite
Takaaki Wajima and Kenzo Munakata
597-600 :
Preparation of n-Type Bi2Te2.85Se0.15 Thermoelectric Semiconductor without Harmful Dopants
Mei Fusa, Natsuki Sumida and Kazuhiro Hasezaki
601-603 :
Nondestructive Assessment of Glass Fibre Composites by Mid-Wave and Near Infrared Vision
Clemente Ibarra-Castanedo, Abdelhakim Bendada, Nicolas P. Avdelidis and Xavier P. V. Maldague
604-609 :
Non-Destructive Evaluation of Weld Structure Using Ultrasonic Imaging Technique
Takahiro Ebuchi, Junichi Kitasaka and Tatsuyuki Nagai
610-616 :
Fast Remaining Thickness Measurement Using a Laser Source Scanning Technique
Muhammad Nor Salim, Takahiro Hayashi, Morimasa Murase, Toshihiro Ito and Shoji Kamiya
617-620 :
In-Service Aged Composite Insulators at Transmission Line Investigated by the Micro-Computerized Tomography
Pietro P. J. C. Silva, Armando H. Shinohara, Admilson P. Pacheco, Zurdival P. Castro Filho and Sergio L. P. Monteiro
621-626 :
Ultrasonic Imaging of Concrete by Synthetic Aperture Focusing Technique Based on Hilbert-Huang Transform of Time Domain Data
Oscar Victor M. Antonio Jr. and Sohichi Hirose
627-630 :
Numerical Analysis of Microwave NDT Applied to Piping Inspection
Yasutomo Sakai, Noritaka Yusa, Satoshi Ito and Hidetoshi Hashizume
631-635 :
Investigation of the Sound Field of Phased Array Using the Photoelastic Visualization Technique and the Accurate FEM
Sho Washimori, Tsuyoshi Mihara and Hatsuzo Tashiro
636-640 :
Electronic Structures and Thermoelectric Properties of Sb-Doped Type-VIII Clathrate Ba8Ga16Sn30
Yasushi Kono, Koji Akai, Nobuyuki Ohya, Yuhta Saiga, Koichiro Suekuni, Toshiro Takabatake and Setsuo Yamamoto
641-644 :
Temperature and Bias Voltage Dependencies of Spin Injection Signals for Co2FeAl0.5Si0.5/n-GaAs Schottky Tunnel Junction
Tatsuya Saito, Nobuki Tezuka and Satoshi Sugimoto
645-651 :
Oxide Particle Refinement in 4.5 mass%Al Ni-Based ODS Superalloys
Qingxin Tang, Shigeharu Ukai, Naoko Oono, Shigenari Hayashi, Bin Leng, Yoshito Sugino, Wentuo Han and Takanari Okuda
652-657 :
Effects of Two-Step Cold Rolling on Recrystallization Behaviors in ODS Ferritic Steel
Bin Leng, Shigeharu Ukai, Takeshi Narita, Yoshito Sugino, Qingxin Tang, Naoko Oono, Shigenari Hayashi, Farong Wan, Satoshi Ohtsuka and Takeji Kaito
658-661 :
Irregular or Smooth Grain Boundaries Evolved after Secondary Recyrstallization of Fe-3%Si Steel
Hyung-Ki Park, Chang-Soo Park, Tae-Wook Na, Chan-Hee Han and Nong-Moon Hwang
662-670 :
Wettability Model Considering Three-Phase Interfacial Energetics in Particle Method
Shungo Natsui, Rikio Soda, Tatsuya Kon, Shigeru Ueda, Junya Kano, Ryo Inoue and Tatsuro Ariyama
671-675 :
Detection of AE Events due to Cracks in TBC during Spraying Process
Kaita Ito, Hitoshi Kuriki, Makoto Watanabe, Seiji Kuroda and Manabu Enoki
676-680 :
Composition Dependence of Pd-Ag Alloy Proton Injection Layer on Optical Switching Properties of Electrochromic Switchable Mirror
Kazuki Tajima, Yasusei Yamada, Masahisa Okada and Kazuki Yoshimura
681-689 :
Influence of Substrate Temperature on Structure and Adhesion Strength of Fe-Cr-P-C Amorphous Coating Films Produced by Thermal Spraying Technique
Masahiro Komaki, Tsunehiro Mimura, Ryurou Kurahasi, Hirotaka Odahara, Kenji Amiya, Yasunori Saotome and Tohru Yamasaki
690-695 :
Strain-Controlled Fatigue Behavior in Thin Pure Copper Sheet for Smart Stress-Memory Patch
Takayuki Shiraiwa and Manabu Enoki
696-699 :
Observation of Electric Potential Distribution in Model Capacitor Sample Using Electron Holography
Ryuichi Kuramae, Hiroyuki Ono, Yoshinori Fujikawa, Yasukazu Murakami and Daisuke Shindo
700-706 :
Corrosion of Calcium Phosphate Coated AZ31 Magnesium Alloy under a Salt Spray Test
Sachiko Hiromoto
707-715 :
Investigation of Flotation Parameters for Copper Recovery from Enargite and Chalcopyrite Mixed Ore
Kazutoshi Haga, William Tongamp and Atsushi Shibayama
716-723 :
Fine Grains Forming Process, Mechanism of Fine Grain Formation and Properties of Superalloy 718
Hwa-Teng Lee and Wen-Hsin Hou
724-732 :
Cell Proliferation, Corrosion Resistance and Mechanical Properties of Novel Titanium Foam with Sheet Shape
Komei Kato, Akiko Yamamoto, Shojiro Ochiai, Yuzo Daigo, Takeshi Isobe, Suguru Matano and Kenichi Omori
733-738 :
Microstructural Characteristics of InGaZnO Thin Film Using an Electrical Current Method
Yen-Ting Chen, Fei-Yi Hung, Shoou-Jinn Chang, Truan-Sheng Lui and Li-Hui Chen
739-744 :
The Effect of Phases in Nanoparticles Produced by Electrical Wire Explosion on Arsenic(III) Removal
Kyungsun Song, Chang-Yul Suh, Kyung-Seok Ko, Jun-Hwan Bang, Wonbaek Kim and In-Jin Shon
745-751 :
Effects of Thermal Erosion and Wear Resistance on AISI H13 Tool Steel by Various Surface Treatments
Shih-Hsien Chang, Kuo-Tsung Huang and Yung-Hsiang Wang
752-759 :
Electromotive Force of the High-Temperature Concentration Cell Using Al-Doped CaZrO3 as the Electrolyte
Jinxiao Bao, Hiroyuki Ohno, Yuji Okuyama, Norihiko Fukatsu and Noriaki Kurita
760-765 :
Simultaneous Recovery of Gold and Iodine from the Waste Rinse Water of the Semiconductor Industry Using Activated Carbon
Nghiem V. Nguyen, Jinki Jeong, Doyun Shin, Byung-Su Kim, Jae-chun Lee and B. D. Pandey
766-769 :
Microstructure Characterization and Thermal Stability of Nanocrystalline Cu Powders Processed via Cryomilling
Jingchun Liu, Hua Cui, Xianglin Zhou and Jishan Zhang
770-772 :
Structure of Deposits Obtained from Urea-Based Melt Bath Containing Co and La
Shingo Arakawa, Satoshi Oue, Hiroaki Nakano and Shigeo Kobayashi

[JIM HOME] [JOURNAL ARCHIVES]

© 2012 The Japan Institute of Metals
Comments to us : editjt@jim.or.jp