Materials Transactions Online

Materials Transactions, Vol.50 No.4 (2009)

703-710 :
Global Flow of Metal Resources in the Used Automobile Trade
Masaaki Fuse, Kenichi Nakajima and Hiroshi Yagita
711-718 :
Grain Refinement and Superplasticity Induced by Hot Compression of Continuously-Casted Mg-9Al-1Zn-1Ca and Mg-9Al-1Zn Alloys
Masataka Hakamada, Akira Watazu, Naobumi Saito and Hajime Iwasaki
719-722 :
Effect of Vanadium Doping on Structure and Properties of ZnSe Films Prepared by Metal-Organic Vapor Phase Epitaxy
Masahiro Tahashi, Zunyi Wu, Hideo Goto, Youji Hayashi and Toshiyuki Ido
723-726 :
Effect of Cu Addition on the Phase Equilibria in Nd-Fe-B Sintered Magnets
Shota Nishio, Satoshi Sugimoto, Ryota Goto, Masashi Matsuura and Nobuki Tezuka
727-733 :
Heat Treatment of TiH2 Powder to Control Decomposition Phenomenon for Aluminum Foam Fabrication by Melt Route
Kota Kadoi, Norbert Babcsán and Hideo Nakae
734-739 :
Difference in Bioactivity, Initial Cell Attachment and Cell Morphology Observed on the Surface of Hydroxyapatite Ceramics with Controlled Orientation
Takeshi Hagio, Tomohiko Tanase, Jun Akiyama, Masanori Umino, Kazuhiko Iwai and Shigeo Asai
740-743 :
Fatigue Properties of Helium Injected F82H-IEA Heat Material
Norikazu Yamamoto, Yoshiharu Murase and Johsei Nagakawa
744-748 :
Phase-Field Simulation of the Effect of Elastic Inhomogeneity on Microstructure Evolution in Ni-Based Superalloys
Yuhki Tsukada, Yoshinori Murata, Toshiyuki Koyama and Masahiko Morinaga
749-751 :
Preparation and Consolidation of Alumina/Graphene Composite Powders
Ting He, Jianlin Li, Lianjun Wang, Juanjuan Zhu and Wan Jiang
752-758 :
Estimation of Planar Anisotropy of the r-Value in Ferritic Stainless Steel Sheets
Jun-ichi Hamada, Kazuyuki Agata and Hirofumi Inoue
759-764 :
Visualization of Diffusive Hydrogen in Low Alloy Steel by means of Hydrogen Microprint Technique at Elevated Temperatures
Keitaro Horikawa, Hiroaki Okada, Hidetoshi Kobayashi and Wataru Urushihara
765-770 :
Change-Channel Angular Extrusion of Magnesium Alloy AZ31
Tianmo Liu, Jianzhong Liu, Liwei Lu, Yu Liu and Zhongchang Wang
771-775 :
Influence of Severe Plastic Deformation on Precipitation Hardening in an Al-Mg-Si Alloy: Microstructure and Mechanical Properties
Meng-Shan Tsai, Pei-Ling Sun, Po-We Kao and Chih-Pu Chang
776-781 :
Mechanical Properties of Copper Sulfide-Dispersed Lead-Free Bronze
Hidekazu Sueyoshi, Yuki Yamano, Kensuke Inoue, Yoshikazu Maeda and Kosaku Yamada
782-790 :
Modeling Temperature Gradient Evolution of CoSb3 Material for Thermoelectric Devices during Spark Plasma Sintering
Yanhong Cai, Degang Zhao, Xueying Zhao, Lidong Chen, Wan Jiang and Pengcheng Zhai
791-798 :
Effect of Shot Peening on Surface Characteristics and Fatigue Properties of T5-Treated ZK60 Alloy
Wencai Liu, Jie Dong, Ping Zhang, Chunquan Zhai and Wenjiang Ding
799-805 :
Monitoring of Environmental Factors and Corrosion Analysis of Reinforcing Steel in Mortar
Vedarajan Raman and Toshiyasu Nishimura
806-813 :
Equilibrium Phase Relationship between SiC and a Liquid Phase in the Fe-Si-C System at 1523–1723 K
Sakiko Kawanishi, Takeshi Yoshikawa and Toshihiro Tanaka
814-818 :
Excess Vaporization of Na from Na2O-SiO2 Molten Slag by Transfer Thermal Plasma of Ar
Keiichiro Kashimura, Yoshiaki Kitayama and Kazuhiro Nagata
819-824 :
Infrared Reflection Absorption Study for Carbon Monoxide Adsorption on Chromium Deposited Cu(100) Surfaces
T. Wadayama, H. Yoshida, S. Oda and N. Todoroki
825-831 :
Development of Alternative Method of Blasting and Ultra-High Adhesive Strength Thermal Spray Coatings by Vacuum Arc Treatment
Yoshimasa Noda, Akira Sato, Shogo Tobe, Masayuki Hara and Tsuginori Inaba
832-836 :
Evaluation of Grain Refinement and Mechanical Property on Friction Stir Welded Inconel 600
Kuk Hyun Song, Hidetoshi Fujii and Kazuhiro Nakata
837-840 :
Surface Layer Characteristics of TiB2/Al Composite by Stress Peening
Weizhi Luan, Chuanhai Jiang and Vincent Ji
841-846 :
Forgeability and Flow Stress of Mg-Zn-Y Alloys with Long Period Stacking Ordered Structure at Elevated Temperatures
Ryo Matsumoto, Michiaki Yamasaki, Masaaki Otsu and Yoshihito Kawamura
847-852 :
Machinability of Copper Sulfide-Dispersed Lead-Free Bronze
Hidekazu Sueyoshi, Kensuke Inoue, Yuki Yamano, Yoshikazu Maeda and Kosaku Yamada
853-858 :
Thermoelectric Properties of Ca-Ir-O Compounds Prepared by Spark Plasma Sintering
Nittaya Keawprak, Rong Tu and Takashi Goto
859-863 :
Grindability of Dental Cast Ti-Zr Alloys
Masatoshi Takahashi, Masafumi Kikuchi and Osamu Okuno
864-871 :
Thermal Fatigue Cracking and Extension Behaviors of Squeeze Infiltrated Al18B4O33/Mg Functionally Graded Materials
Wook Jin Lee, Bong Gyu Park, Ik Min Park, Yong Ho Park, Jeong Jung Oak and Hisamichi Kimura
872-878 :
Fabrication of Ti-Zr Binary Metallic Wire by Arc-Melt-Type Melt-Extraction Method
Takeshi Nagase, Koichi Kinoshita, Takayoshi Nakano and Yukichi Umakoshi
879-884 :
Development of New Production Technology for Metallic Foam Core Sandwich Panel Using Friction Phenomena
Yong-Jai Kwon, Ichinori Shigematsu and Naobumi Saito
885-890 :
The Influence of Canning HIP Treatment on the Microstructure Characters of Cr35-Si65 and Cr50-Si50 Targets
Chung-Hung Tam, Shih-Chin Lee and Shih-Hsien Chang
891-898 :
Effect of O2-Plasma Treatment on Surface Characteristics and Osteoblast-Like MG-63 Cells Response of Ti-30Nb-1Fe-1Hf Alloy
En-Yu Wu, Keng-Liang Ou, Shih-Fu Ou, Klaus D. Jandt and Yung-Ning Pan
899-908 :
Effects of Thermal Storage and Cu Addition on Adhesive Strength and Microstructure of Sn-3.0 mass% Ag-1.5 mass% Sb-xCu Solder Joints
Hwa-Teng Lee and Wen-Yeong Huang
909-916 :
Optimization of Pressure and Soaking Time of HIP Treatment on 713LC Cast Superalloy
Shih-Hsien Chang
917-921 :
Kinetic Approach for Growth and Coalescence of Nano-Size Oxide Particles in 9Cr-ODS Steel Using High-Energy Synchrotron Radiation X-rays in SPring-8
Sa-Woong Kim, Takahisa Shobu, Satoshi Ohtsuka, Takeji Kaito, Masaki Inoue and Masato Ohnuma
922-925 :
Optoelectronic Characteristics of UV Photodetector Based on ZnO Nanopillar Thin Films Prepared by Sol-Gel Method
K. J. Chen, F. Y. Hung, S. J. Chang and S. J. Young
926-929 :
Hardening Behavior of a 304 Stainless Steel Containing Deformation-Induced Martensite during Static Strain Aging
Sang Hun Lee, Jeom Yong Choi and Won Jong Nam
930-933 :
Development of High-Pressure Sliding Process for Microstructural Refinement of Rectangular Metallic Sheets
Tadayoshi Fujioka and Zenji Horita
934-937 :
Elastic and Superelastic Properties of NiFeCoGa Fibers Grown by Micro-Pulling-Down Method
K. Oikawa, R. Saito, K. Anzai, H. Ishikawa, Y. Sutou, T. Omori, A. Yoshikawa, V. A. Chernenko, S. Besseghini, A. Gambardella, R. Kainuma and K. Ishida

[JIM HOME] [JOURNAL ARCHIVES]

© 2009 The Japan Institute of Metals
Comments to us : editjt@jim.or.jp