Materials Transactions Online

Materials Transactions, Vol.47 No.01 (2006) pp.149-155
© 2006 The Japan Institute of Metals

Combustion Synthesis of Doped Lanthanum Gallate as an Electrolyte for Solid Oxide Fuel Cells

Hiroyuki Ishikawa1,, Makiko Enoki2, Tatsumi Ishihara2 and Tomohiro Akiyama1

1Center for Advanced Research of Energy Conversion Materials, Hokkaido University, Sapporo 060-8628, Japan
2Department of Applied Chemistry, Faculty of Engineering, Kyusyu University, Fukuoka 812-8581, Japan

Solid oxide fuel cells, SOFCs, have attracted worldwide attention from wide applicability in a large-sized power plant, a distributed power supply, and an efficient cogeneration apparatus with extremely high efficiency of power generation. Doped-lanthanum gallate (La(Sr)Ga(Mg)O3), which has been recently proposed as a new solid electrolyte, replaces Yttria Stabilized Zirconia (YSZ), lowers the operating temperature of SOFC and then improves the mechanical reliability of the cells. In this study, the doped-lanthanum gallate was produced by combustion synthesis and its sintering behavior, the electrical conductivity, and life cycle assessment of this process from energy requirement and a carbon dioxide emission were analyzed by comparing with the conventional solid-state method. In the experiments of the combustion synthesis, lanthanum oxide, strontium carbonate, gallium oxide, metallic magnesium, and sodium perchlorate were well mixed with different substitution ratios of gallium by magnesium; 80, 60, 40, and 30 mole%, by using a ball mill and were ignited at one end of the mixture at nitrogen atmosphere to complete the combustion wave propagation of the exothermic reaction to the other end without any additional energy. As a result, all of the products, except the 80 mole% magnesium-containing lot, showed definite peaks of intermediates containing lanthanum gallate in X-Ray Diffraction (XRD) patterns. Most significantly, the product containing 30 mole% magnesium, which was completely sintered at 100 K lower temperature (1673 K) compared to the solid state method (1773 K), showed the highest electrical conductivity, 0.08 Scm-1 at 1073 K without the dependency of oxygen partial pressure, being almost the same as the world record. The results demonstrated that the combustion synthesis of SOFC electrolyte had the possibility of an innovative production process with several benefits, such as shortening of processing time, minimizing energy requirement and carbon dioxide emission, and deriving the excellent property of SOFCs.

(Received 2005/8/25; Accepted 2005/11/16; Published 2006/1/15)

Keywords: Solid Oxide Fuel Cell (SOFC), combustion synthesis, doped lanthanum gallate (La(Sr)Ga(Mg)O3), perovskite type oxide, electrolyte, electrical conductivity

PDF(Free)PDF (Free) Table of ContentsTable of Contents

REFERENCES

  1. T. Ishihara, H. Matsuda and Y. Takita: J. Am. Chem. Soc. 116 (1994) 3801--3803.
  2. T. Ishihara, M. Honda, T. Shibayama, H. Minami, H. Nishiguchi and Y. Takita: J. Electrochem. Soc. 145 (1998) 3177--3182.
  3. T. Ishihara, H. Minami, H. Matsuda, H. Nishiguchi and Y. Takita: Chem. Commun. 8 (1996) 929--930.
  4. Z. A. Munir and U. Anselmi-Tamburini: Self-Propagating Exothermic Reactions: The Synthesis of High Temperature Materials by Combustion, (North-Holland, 1989), pp.~277--365.
  5. T. Akiyama, Y. Hirai and N. Ishikawa: Mater. Trans. 42 (2001) 460--463.
  6. T. Akiyama, H. Isogai and J. Yagi: Int. J. Self-Propag. High-Temp. Syn. 4 (1995) 69--77.
  7. A. A. Shiryaev, M. D. Nersesyan, Q. Ming and Dan Luss: J. Mater. Syn. Proc. 7 (1999) 83--90.
  8. Q. Ming, M. D. Nersesyan, J. T. Richardson and Dan Luss: J. Mater. Sci. 35 (2000) 3599--3606.
  9. Y. Wang, X. Liu, G. D. Yao, R. C. Liebermann and M. Dudley: Mater. Sci. Eng. A 132 (1991) 13--21.
  10. K. Huang, R. Tichy and J. B. Goodenough: J. Am. Ceram. Soc. 81 (1998) 2576.
  11. P. R. Slater, J. T. S. Irvine, T. Ishihara and Y. Takita: J. Solid State Chem. 139 (1998) 135--143.
  12. R. H. Perry, D. W. Green and J. O. Maloney: Perry's Chemical Engineers' Handbook 6th edition, (McGraw-Hill, 1984) pp.~20--36.
  13. W. Buchner: Industrial Inorganic Chemistry (Weinheim, 1933).
  14. P. F. Chapman and F. Roberts: Metal Resources and Energy (Butterworths, 1983).
  15. Minerals Yearbook, Section Minerals (the Bureau of Mines, the United States, 1989).
  16. Inventory Data of Materials (IDEMAT) (Delft University Clean Technology Institute, 1995).
  17. Forests and Landscape (FOEFL or BUWAL) Environmental Series No.~132 (Swiss Federal Office of Environment, Switzerland, 1991) pp.~A59.
  18. Guideline for Calculation Method of Green House Gas Emission from Trade Association (Ministry of the Environment, Japan, 2003) pp.~2--7.

[JIM HOME] [JOURNAL ARCHIVES]

© 2002 The Japan Institute of Metals
Comments to us : editjt@jim.or.jp